PCR tube eight tubes are mainly used for high-precision biology, medicine, chemistry and other PCR experiments, usually made of polypropylene PP. It is made of ultra-thin and uniform material, which can be applied to most ordinary and quantitative PCR instruments. It can be used for quantitative and ordinary PCR experiments to identify the direction of the letter mark. The tube cap has strong versatility and is available in transparent and white.
Features of pcr tube eight strips:
1. This product combines the functions of opening and closing the cap very well. Use this device to open the cap before adding samples. After adding samples, you can use this device to cover the caps of eight tubes or a single PCR tube at the same time, which is more convenient. It is conducive to work and has high work efficiency, which effectively solves a series of problems such as low working speed, influence of external temperature on experimental results, easy contamination of the inner side of the tube cover, etc. caused by opening and closing the cap of the PCR tube with bare hands.
2. This product is mechanically interlocked. Using the principle of leverage, it can greatly open and close the caps of PCR tubes and eight-tube tubes. The operation is simple and labor-saving.
3. The whole can be sterilized and sterilized, and the eight tubes of PCR tube can greatly reduce the cross-contamination caused by operation.
pcr plate
Precautions for the use of PCR tube eight tubes:
1. Do not use without training and evaluation.
2. Choose the appropriate rotor and speed, do not use it.
3. Choose an appropriate temperature, usually 4°C, not lower than the organic solvent, to avoid freezing and damage to the eight-tube tube and rotor of the PCR tube.
4. Before using the rotor, wipe the tube with the hole rod and carefully check whether there are cracks and white spots at the bottom of the hole. If so, turn around and scrap it.
5. The amount of solution filled into the eight-tube strip of PCR tube must be appropriate. The stainless steel tube has no cover and only fits 2/3. A plastic tube can be attached to the shoulder. The lid must be closed and no leakage is allowed. Empty tubes are centrifuged and deformed. The use of organic solvents in plastic pipes must comply with regulations.
6. The eight-tube strips of PCR tubes must be placed in pairs, and must be tightly balanced, with a deviation of <0.1g.
7. If you don't turn, you are not allowed to turn. To handle the rotor, the handle must be used to prevent the rotor from slipping. Turn your headlights and hold steady. Hold the handle with your hand and turn your head as you turn the handle. The spinner cap should be tightly closed and the cap does not allow centrifugation.
8. Do not open the cover when using. Centrifuges are not supported. If the sound and vibration are abnormal, stop immediately.
9. After using the rotor, it must be removed in time and dried in the rotor chamber, and the tube hole should be carefully cleaned with a cleaning stick. If the solution is spilled, it must be cleaned, wipe the condensation in the rotor chamber, and then open the door to dry the rotor chamber.
The above is the introduction of the three characteristics and precautions for use of the eight-tube PCR tube, for your reference!
